Have you ever wondered how to safely take off your surgical gloves without contaminating your hands? Fear not; I’ve got you covered! Check out Kevin’s 3D-printed surgical glove remover to ensure a clean and safe removal process.
The Glove Remover PPE performance (personal protection equipment) safety product helps reduce the spread of infection while changing protective rubber gloves and promoting efficiency and convenience.
The glove remover was conceived during the coronavirus pandemic. You are welcome to share your recommendations for additional improvement with anyone you think would benefit.
We would appreciate it. Likewise, we are happy to receive feedback from environmental services officials or medical offices that might want to try one of our glove removers.
This device is essential for clinical staff or persons in the beauty care industry or the food industry. Also, a tattoo artist can use the glove remover to dispose of gloves.
Users must take care not to tear or split their gloves while removing them. Studies have indicated that this can happen if the glove remover isn’t used correctly.
Who Can Use The Glove Remover?
Every individual who wears protective gloves needs to dispose of them frequently.
COVID-19: Glove remover decreases the danger of contamination.
Glove remover is quite versatile; it can be mounted to walls, pipes, or tubes.
Instructions to mount the glove remover:
Mount the glove remover so that its tip is between 60 and 80 cm (24-31 inches) above the waste container on the floor, using a low-profile waste container underneath.
Wall mounting:
Wall mounting: Insa the wall mounting plate (two teeth) with two screws vertically, one over the other on an appropriate divider.
Supplement the glove remover into the wall mounting plate and screw it on. Use two screws for plastics on each side.
Pipe mounting:
Utilize a measurement of 2.5 cm (1 inch). For smaller channels, wrap tape over a width of 6 cm (2.5 inches) around the funnel until a sufficient breadth is reached.
Cinch the glove remover to the pipe utilizing the channel mounting plate (4 semi-round). Use four screws specifically for plastics and screw them into the funnel mounting plate from behind—the world’s first glove remover:
3D printed by 3dprintingbykevin.com and prepared to battle COVID-19.
Get yours today from 3dprintingbykevin.com.
The most effective method to use glove remover
1. Turn the palm of your hand towards the device without contacting it.
2. Point the tip of the glove remover against your wrist. Then slide the tongue into the glove between the palm of your hand and the glove sleeve.
3. Draw your hand upwards, and the glove will roll right off and drop into the waste bucket. Please take caution to never contact the glove remover with the outside of your glove.
NOTE: If your glove does contact the glove remover, please disinfect the glove remover and whatever else touched it immediately.
Health Information
The glove remover works best with generally used nitrile rubber gloves that are not tight-fitting or have a low cuff.
The glove remover shouldn’t be used to pull off surgical gloves, chemotherapy gloves, and other tight-fitting gloves with a high sleeve since they are bound to tear.
If the glove tears, the skin, clothing, and glove remover can be contaminated. Yet, it is your job as the user to conduct yourself carefully. The glove remover ought to be disinfected consistently.
We hope you found this article helpful. If you did, please let us know by leaving a comment or question on the website. Also, if you know someone who might benefit from this information, please share it.
Bullwinkle
Disclaimer: Kevin’s 3D Printing accepts no responsibility for any injury or damage caused by the production or use of the glove remover.